Starlink Gen 3 Universal Roof Mount with 12V Power Kit, and Window Cable Pass through.

From the manufacturer:

After thousands of miles testing these mounts in some of the most extreme conditions, we are absolutely confident they can handle whatever your next adventure throws at them.

.

Our industry leading design includes an aluminum outer housing offering the highest level of protection against road debris, rocks, tree branches, and high winds. We have tested the system repeatedly and found NO RF interference from the aluminum housing. (Obstruction testing and speed testing)

.

Below the aluminum, the dish is safely nested inside a .75" thick CNC cut block of HDPE. Installing your dish couldn't be easier. Simply unscrew a few screws on the mount and slide your dish in. Unlike our competitors, you do NOT need to unscrew the entire mount to remove the dish.

12V Power Kit

Our Gen 3 12V power supply plugs directly into the Gen 3 Starlink Router. This eliminates the wasted idle draw of powering it through a large inverter (30-50 watts waste for a 3000W inverter!).

Simply unplug the 110V Starlink power supply and plug in our 336W power supply and connect it to a 12V OR 24V power source (Input voltage range is 10-30V). Our converter boosts this to the 56V that the Gen 3 router and dish need.

After testing numerous power supplies we finally had one manufactured overseas. To eliminate any concern about ripple voltage (and subsequent drop outs and/or reduced speeds), we install a capacitor as well as the appropriate barrel connector that works seamlessly with the Starlink Gen 3 router.

Power Consumption tested over 1 hour with constant upload/download internet: 63 Wh (4.5A at 13.8V).

** NOTE: Using snow melt function draws an additional 120W and cannot be used with cigarette lighter plug as most vehicles have a 10A limit.

CABLE PASS THROUGH:

This product is designed to minimize air and moisture entering your vehicle while allowing you to pass your Starlink cord through. Made of EPDM Foam, the top portion will mold itself into the shape of the opening to reduce air or water passing into the vehicle. The bottom of the product is made of a stiff, ridged material with a .25" opening designed to fit over your window glass.

Total product length is 36" long with the cord opening hole cut approx 3" from one end. Can be installed from the left or right. Easily trim to desired length using a razor blade. Designed to work with the .28" thick Starlink cord but is flexible to work with cords a bit bigger or smaller.

NO cord cutting or cable modifications are required for this product. Simply slide your cord or cable through.