You are offerding on one SGI Fuel Workstation in moderate overall cosmetic condition offered as a repair project or source of parts.
The door hatch is present but has broken off. The outside of the case has some scratches and scuffs.

Not working: powers on briefly, then shuts down.

The internal L1 controller communicates over serial and reports low-voltage faults involving the 1.5 V supply. Troubleshooting suggests a possible processor-module/PIMM fault, but the cause has not been conclusively diagnosed. We confirmed both 5V and 12V power supplies were in the right neighborhood when powered on. The system has not booted into IRIX during testing. We did some component level checks on the PIMM board and were not able to isolate the fault. As a result the PIMM board shows some signs of module, SGI part number 030-1730-002

V10 32 MB graphics, part number 030-1826-002 Rev. A

Four installed memory modules

Tape drive and optical drive

Installed power supply

Both hard drives have been removed. No operating system is included. Memory capacity has not been verified, and the graphics, memory, tape drive, optical drive, and power supply are not guaranteed functional.

Testing with each memory pair separately and with the storage drives disconnected did not resolve the shutdown. Additional faults may be present; replacing the processor module is not guaranteed to restore operation.

Please review the photos for cosmetic condition and included components. Sold for parts or not working, with the faults described above.