Frequency Range: 698-960/1700-2700MHz
Polarization :±45°
Bandwidth :262/1000MhH
Gain :2x14dBi
Horizontal Half-power Beam Width: 65°
Vertical Half-power Beam Width :50°
VSWR :≤1.5
Maximum input power :50Ω
Lightning protection :DC Ground
Input connector type :2 x N female
Dimensions: 260*170*60mm
Antenna weight :0.72kg
Radome material :ABS
Radome color :White
Operating temperature: -40℃～60℃
Rated Wind Velocit :60m/s
Waterproof Standard: IP67
Mounting way :wall-hanging or pole-holding
Mounting hardware :￠35mm～￠50mm
It is mimo antennas ,has 2 coax connections ,means it has 2 internal radiating antennas which an LTE routers uses to improve signal quality and data throughput. The advantage of mimo antenna is that the signal-to-noise ratio is better than single polarization antenna,causes much more data speed.
Works on 3G, 4G, LTE, GSM & CDMA, Wide Frequency Band : 698-2700 MHz.Include 800MHz, 850MHz, 900MHz, 1800MHz ,1900MHz , 2100MHz and wifi 2.4ghz bands ,etc .
Higher Gain :2x14dBi.What is the dbi? dbi is a measurement of the power. The theory is, increasing the dbi will increase the range.
Work for routers, modems which have external antenna port .Support All Operator as Verizon, AT&T, T-Mobile, Telus, Bell Canada, Rogers, DigiCel,etc .
Use skills:Any antenna is heavily dependent on the surroundings.To achieve better results you may have to move around your hotspot and antenna（height and location of the installation）until you determine a sweet spot that gives you the best rewards.You must take into considerations, antenna hight, location,building clearance, line of sight,etc.
What type of cable should the antenna be equipped with:50ohm (lower signal loss),as LMR240,LMR400 etc .Signal will improve depends on the length of the cable.the router antenna does not require power,it is just plug and play ,don't need any setting up.
What connector cable should be used：You will need two cable with N-Male on the end (for this antenna). The type of connector at the other end of the wire depends on your equipment（SMA male, N female,TS-9 etc.).
Lightning arester:If you need to mount the antenna on a roof or very high, and you are in a lightning-prone area, it is recommended to install a lightning arrester.if you need lightning arrester /LMR400 cable or other antenna,you can visit my Amazon store and order.
Package :1x mimo panel antenna ,1set hardware (bracket ,u-bolts, nuts, washers, lock washers).2pcs 10meters RG58/ 50-3 cable(with SMA connector), TS-9 adapter, J-Mount Pole.
