Item/Description
This listing is for:
Cisco 40X10GE-WLO CRS 40x10 Gigabit Ethernet Interface Module
Mfg: Cisco
P/N:40X10GE-WLO
Condition:
Equipment is in good/used condition, may have minor cosmetic wear/scratches
Please note: Photo used in this listing is a Stock photo.
This equipment is used, was pulled from a working environment, is in stock and ready toship
Payment:
Payments accepted via PayPal only
Warranty/Returns:
·90-Day warranty
·Returns accepted for defectiveitems
·20% Restocking fee fornon-defective items
Please contact us with anyquestions. Thank you
PICS Telecom is a leadingglobal distributor of telecom and data equipment, backed by 28+ years ofindustry experience.
From Cisco...
Product Specifications
Table 1 gives specifications of the Cisco CRS 40x10 Gigabit Ethernet Interface Module.
Table 1.Product Specifications
Feature
Description
Chassis compatibility
●Compatible with enhanced Cisco CRS line-card chassis (400-Gbps mode)●Compatible with legacy Cisco CRS line-chard chassis (200-Gbps mode)●Requires 400-Gbps fabric cards●Requires 400-Gbps modular services card or forwarding processor card for operation
Software compatibility
Cisco IOS XR Software Release 5.1.1 or later
Port density
Forty ports of 10 Gigabit Ethernet per PLIM slot
Protocols supported
Encapsulations: ARPA, IEEE 802.2/SAP, and IEEE 802.3/SNAP
●IEEE 802.x flow control●802.1q VLAN support, jumbo frames●IEEE 802.1p tagging●Source and destination MAC accounting and VLAN accounting●Full-duplex operation●802.1Q VLAN termination●Per-port byte and packet counters for policy drops, oversubscription drops, cyclic redundancy check (CRC) error drops, packet sizes, and unicast, multicast, and broadcast packets●Per-VLAN byte and packet counters for policy drops, oversubscription drops, and unicast, multicast, and broadcast packets●Per-port byte counters for good bytes and dropped bytes●10 Gigabit Ethernet configurable LAN/WAN-PHY support●Synchronous Ethernet●1588●OUT-2e
OTN (G.709 feature summary)
ITU G.709
●Alarm reporting: Loss of signal (LOS), loss of OTN frame (LOF), and loss of OTN multiframe (LOM)●OTU alarm indication signal (OTU-AIS), OTU backward defect indication (OTU-BDI), ODU alarm indication signal (ODU-AIS), ODU open connection indication (ODU-OCI), ODU locked (ODU-LCK), ODU backwards defect indication (ODU-BDI), ODU payload type identifier mismatch (ODU-PTIM), OTU signal fail (OTU_SF_BER), and OTU signal degrade (OTU_SD_BER)●OTU_SF_BER and OTU_SD_BER alarms are based on monitoring of OTU BIP errors with a user-configurable threshold crossing●Error counts: OTU BIP, OTU BEI, ODU BIP, and ODU BEI●Threshold crossing alerts (TCAs) for OTU BIP errors (SM-TCA) and ODU BIP errors (PM-TCA) with user-configurable threshold●Local (internal) and line (network) loopback
Performance
●400-Gbps line-rate throughput●Maximum number of IM per chassis: 8 slot (8), 16 slot (16)
Reliability and availability
●Line-card online insertion and removal (OIR) support without affecting the system
Network management
●Cisco IOS XR Software command-line interface (CLI)●Simple Network Management Protocol (SNMP)●Extensible Markup Language (XML) interface●CraftWorks Interface (CWI)●Cisco Active Network Abstraction (ANA)
Physical dimensions
Occupies one-half slot in a Cisco CRS chassis:
●Weight: 7.85 lb (3.55 kg)●Height: 20.6 in. (52.2 cm)●Depth: 11.2 in. (28.4 cm)●Width: 1.8 in. (4.49 cm)
Power
Expected value < 110W in 400-Gbps mode, <80W in 200-Gbps mode.
Energy monitor functionality allows real-time power monitoring of each individual component: PLIMs and line cards, fabric, PRP through CLI beginning with IOS XR Release 5.1.1.
Environmental conditions
Storage temperature: -40 to 158°F (-40 to 70°C)
Operating temperature:
●Normal: 41 to 104°F (5 to 40°C)●Short-term: 23 to 122°F (-5 to 50°C)
Relative humidity:
●Normal: 5 to 85%●Short-term: 5 to 90% but not to exceed 0.024 kg water/kg of dry air
Short-term refers to a period of not more than 96 consecutive hours and a total of not more than 15 days in 1 year. (This refers to a total of 360 hours in any given year, but no more than 15 occurrences during that 1-year period.)
PicsTelecom will, prior to shipping used electronics equipment and components thatcontain FMs, either domestically or internationally, assure and identify eachshipment as either: (1) Tested for Full Functions, R2/Ready for Reuse; (2)Tested for Key Functions, R2/Ready for Resale; and/or (3) Evaluated andNon-Functioning, R2/Ready for Repair.
