Notes： CB1 will send newest version CB1 V2.2
Brief IntroductionBIGTREETECH CB1 is an alternative to Raspberry Pi CM4, which is currently out of stock. BIGTREETECH M4P is a 4-axis motherboard using a CM4 BTB header, which can work with CB1 or CM4 perfectly.
Main Features
CB11. CPU: Allwinner H616, Quad-core Cortex-A53 @1.5GHz2. GPU: Mali G31 MP2, support OpenGL3.23. RAM: 512MB/1GB DDR3L SDRAM4. Display: HDMI2.0A interface, support 4K display5. USB 2.0 port6. 100M Ethernet + 100M WiFi7. The same BTB header as the Raspberry Pi CM4
M4P1. DSI1, CSI1 interface (for CM4)2. Gigabit Ethernet interface (1000M for CM4, 100M for CB1)3. 3 USB 2.0 ports4. Equipping the ESD protection chip on the USB and Ethernet ports to prevent beingbroken down by the static electricity5. When working with Raspberry Pi CM4, its 40pin pin header has the same functionas that of Raspberry Pi(Custom IO for CB1)6. Using a BTB board-to-board connection, which can be further reinforced withscrews, perfectly compatible with CB1 or Raspberry Pi CM47. The MCU adopts STM32G0B0RE 32-bit ARM Cortex-M0+ @64MHz chip8. The power chip adopts TPS5450-5A, which supports DC12/24V power input, theoutput current of the chip is up to 5A, and the peak value can reach 6A, whichperfectly supports the power supply of the core board9. The protection circuit of the thermistor part prevents the main control chip fromburning due to leakage of the heated bed or heater cartridge10. In CNC fan ports: FAN0, FAN1, and FAN2, a 24V (DCIN) or 5V power supply canbe selected with a jumper cap (Note: the voltage of the three CNC fans should bethe same, and cannot be set to different voltages individually)11. MCU firmware can be upgraded through SD card, or through DFU with Klipper'smake flash command12. On-board TMC-driven SPI and UART working modes, on-board DIAG functionpins, can be used by simply plugging and unplugging the jumper cap13. Support filament runout detection, BLTouch, RGB lights...14. Adopt replaceable fuse for easy replacement