BIGTREETECH Manta E3EZ V1.0 Mainboard 32 Bit Control Board for Ender3
Features: BTB connectors are adopted between the motherboard and board, allowing the choice of other board in addition to CM4.
MCU firmware can be upgraded card, or use DFU Klipper's make command.
Onboard DIAG pin, easily configurable with jumpers.
Onboard SPI and UART of driver, which can be used directly without a jumper.
Onboard SPI for connecting acceleration to enable Klipper's input shaping.
Support power loss recovery, filament runout auto power-off, BLTouch, RGB,
TPS5450-5A power supply chip supports DC12/24V power input, current output rated at 5A continuous and 6A instantaneous, sufficient power supply for
The temperature adopts a high-precision pull-up resistor.
The thermistor circuit is protected to prevent MCU damage from shorted heated bed and heater cartridge
32bit 64MHz ARM Cortex-M0+ series STM32G0B1RE MCU.
Brand new andSpecifications: Size：90.8x120mm
MCU：ARM Cortex-M0+ STM32G0B1RE 64MHz
Motherboard DC12V-DC24V
Motor DC12V-DC56V
3.3V
Heater Connection：Heated Bed Heater Cartridge (HE0, HE1)
Port Current：10A Continuous, 11A Instantaneous
Heater Cartridge Current：5A Continuous, 6A Instantaneous
Fan Port：3 2 On
Fan Port Current：1A Continuous, 1.5A Instantaneous
Overall Current(Heater Cartridge+Driver+All Fans)：＜10A
Expansion Port：BLTouch, PS-ON, PWR-DET, Fil-DET, RGB, CAN FD, SPI
Motor Driver：Support EZ5160, EZ2209, EZ2208, EZ2225, EZ2226, EZ2130, EZ6609...
Thermistor：3 100K
PC Connection：Micro-USBPackage Includes: 1 E3EZ V1.0 Motherboardnote: Due to the problems of lighting effects and angles, there will be certain tolerances in the product, please understand.
Please allow 0-1cm error due to the manual measurment.