Made in USAfromABSfor high heat resistance.

Our Pro Mount has holes to fit common low-voltage electrical boxes: single gang, octagon, round, square, and T-bar.

Our Lite Mount has holes for round boxes and T-bar.

Both the Pro and Lite have holes that match their respective default Ubiquiti pattern.
Our Pro Mount is Compatible with:
Our Lite Mount is Compatible with:
1x Mounting Bracket

NotIncluded:

We are not affiliated with Ubiquiti.

Competitors use PLA and PETG which are not recommended for this application. Access Points can get quite hot under load. The AP operating range is-10 to 70° C (14 to 158° F). PLA can start to deform at only 55°C (131° F) and PETG at 70°C (158° F). ABS can withstand up to 85°C (185° F).

Only the specific models listed are compatible with these mounts. Ubiquiti has many legacy models, check your model number before ordering.