About this product
【Function - Dryer and Storage Box】SUNLU Dry Box is specially used for drying 3D printer filament for removing moisture from spool. It keeps 3D filaments dry during printing and can be used to dry filaments for storage.
【Heating, Rotating and Constant Temperature】The storage box will keep heating up to the preset temperature and continue to work until the preset time is reached. The SUNLU housing has two built-in rotating shafts that allow the filament to rotate continuously in the dry heat box to remove moisture.
【SIMPLE BUT EFFECTIVE】The filament dryer box is very simple to use, even with only two buttons, it can enrich many functions, such as setting temperature and time, loading current target temperature data and current temperature.
【SET TEMPERATURE AND TIME】The dryer box is preset to run for 6 hours at 50℃ and should be compatible with any material of any diameter filament. But you can click the button to reset the temperature between 35-55℃, or long press the left button to reset the working time 0-24 hours.
【QUIET AND BEAUTIFUL】SUNLU Filament Dryer Storage Box is very quiet at work and can be used in the bedroom with a silent 3D printer without disturbing you. Simple and beautiful design with transparent lid and white bottom.Say No to Moisture Filaments
If the filaments are moisture, SUNLU Filadryer S1 can dry it evenly and improve the printing effect greatly. It helps you avoid wasting filaments and printing failure.
Easy Operation
It is very easy to operate SUNLU filadryer S1. Click right bottom to set heating temp; Press the left bottom for 3 seconds to set heating time. (PV means the actual heating temp in the dryer box; SV means the temp you set)
Say Good Bye to Failure
SUNLU Filadryer S1 is designed to help you solve the printing problems like Clogging, Layer shift, Stringing and Ahesion.
Get Moisture out of Filaments
It can greatly helps you get better printing results without stringing,clogging and layer shift. SUNLU filadryer S1 makes your damp filaments alive again.
Temp is Adjustable Up to 55℃
Temperature can be adjusted ranging from 35℃~55℃. It can dry many kinds of 3d filaments(1.75mm/2.85mm/3mm PLA,PLA Plus,PETG,ABS,TPU...).Drying when you are printing models, it can improve the printing quality and get better printing results. Filadryer S1 is the best 3d printing mate.
