Simply put: The Last 1U Rails you will need for your data center!24" to 31" adjustable and a sturdy 1.25" galvanized steel shelf on all 4 corners.
New 18GA Design is LASER CUT, thicker and stronger!
These are A SET(2 pieces left and 2 pieces right) of Generic+Universal 1U Rails from American Rails(US).
Compatible with Compaq, SuperMicro, Dell, IBM and more(almost any server, really)!
The 'Shelf Support' is 1.25" underneath and 11" front to back(Depth) on ALL 4 SIDES.That's 55 square inches of support for your servers!
BIG ADVANTAGES over ALL other rails:1.) Put these rails in ONCE with 2 mounting bolts on each corner(min 8) and you'll NEVER have to re-rail a cabinet again!2.) They are made to support a FULL CABINET(FULL 42U rack/cabinet density)!3.) These support the Front and Back of the server with a 1.25" footer(shelf).
Other "universal rails" have two fundamental flaws because they are designed with an offset from the 1U bottom(foot) which wastes nearly 1/2" vertical space. This means that by design you will NOT be able to get a cabinet FULL with 42U.The American Rails(US) 1U rails are UNIVERSAL: No more dealing with side rail sets that require screwing into the case No more highly specific bearings that break No more difficult release pins to pull a server outStack one 1U servers in the rack and never have to remove them!
Made from 18GA Galvanized steel, they can support up to 70 lbs!Two locking nuts on each side can be tightened with Phillips head screwdriver and will never need to be reconfigured.No special tools involved for permanent setup.
They are automatically centered on a 24" depth.They can support cabinet depth(front to back) from 24" to 31".
The mounting holes fit most modern racks and can hold 1x1U server.
Easy to install with your existing cabinet nuts and mounting bolts.Also, no need to mount anything to the side of your server, just slide these into position and you are done!
Manufactured is Atlanta, GA!
Let us know if you have need of larger quantities!