HPE DL325 Gen10+ Plus 2SFF U.2 SCN Parts Kit Cage+Backplane+Power+Signal CableThis listing is for 1 (one) HPE DL325 Gen10 Plus U.2 SCN Enable KitWe can integrate this info a complete solutionIncludes:2x SFF Smart Carrier NVMe Drive CageU.2 BackplanePower CableNVMe Signal cableScrewsAlso works with DL325 Gen10 Plus V2 and DL365 Gen10 Plus with minor adjustmentsPlease contact us with any questionsThank youASLOC: B-R3-S6This listing is for HPE ProLiant DL3X5 DL385 Gen11 8SFF Tri-Mode U.3 x4 BC Backplane Kit
Compatible with the following servers:-HPE ProLiant DL345 Gen11-HPE ProLiant DL385 Gen11We can integrate this into a full solution
This kit includes:- 8x SFF Smart Carrier NVMe Drive Cage- U.3 Backplane UBM6 (SATA/SAS/NVMe U.3)- Hard drive blanks
Notes for HPE ProLiant DL345 Gen11:− Supports 8 SFF SAS/SATA/ NVMe (U.3) Basic Carrier (BC) Drives at the front− This drive cage can only be selected with the 8SFF CTO server (P54205-B21)− Max = 3− If one(1) of this backplane is selected then one of the following cable options is supported: ο With PCIe controllers: 8SFF x4 Tri-Mode Box3 Primary Cable Kit (P57127-B21). ο NVMe Direct attach (x4 bandwidth): 8SFF x4 NVMe Box3 Direct Attach Cable Kit (P57124-B21) and cannot select 4PCIE Enablement Kit (P57116-B21).− if three (3) of this backplane is selected then one of the following cable options is supported: ο NVNe Direct Attach (x2 bandwidth): 24SFF x2 NVMe Box1-3 Direct Attach Cable Kit (P57126-B21). ο NVMe Direct Attach (x4 bandwidth): Requires two (2) OCP retimers and Direct Attach cable kit (P57125-B21) ο With PCIe controllers (x2 bandwidth): 24SFF x2 Tri-Mode Box1-3 Cable Kit (P57129-B21). ο With PCIe controllers (x4 bandwidth): 24SFF x4 Tri-Mode Box1-3 Primary/Secondary Cable Kit (P57128-B21).
Notes for HPE ProLiant DL385 Gen11:− x4 U.3 8SFF Drive cage can support NVMe and SAS/SATA drives− Backplane power cable kit needs to be selected to support this backplane− Configurable up to 3− OROC and PCIe controllers support this backplane. OROC x2/x4 or PCIe x2/x4 cable kit selection is needed for controller support− Mixture of x1 U.3 8SFF and x4 U.3 8SFF backplanes is ALLOWED− Mid cage cannot be supported if server has mixture of x1 U.3 8SFF and x4 U.3 8SFF backplanes
Please contact us with any questionsThank you
LOC: OFC-ST-R11-S1-F