TESTING & COSMETIC NOTES:
This is a USED WORKING item in GOOD cosmetic condition that IS THOROUGHLY TESTED and is GUARANTEED WORKING
This unit has been factory reset, view console log for more info. Login/password is admin/password. Power cords NOT included.
COMPONENTS INCLUDED IN THIS sale:• (1) - BROCADE DCX 8510-4 8U GEN 5 FIBRE CHANNEL ENCLOSURE DCX85104 BR-DCX8514-0002 80-1006964-04
• (46) - BROCADE 57-0000088-01 16GB SW 850NM SFP+ GBIC 125M SAN SWITCH TRANSCEIVER
• (2) - BROCADE CR16-4 ULTRASCALE ICL QSFP BLADE MODULE
• (2) - BROCADE CP8 CONTROL PROCESSOR BLADE
• (1) - BROCADE FC16-48 16GB 48-PORT FC FIBRE CHANNEL BLADE MODULE
REPLACEMENT or MONEY BACK GUARANTEE:When you receive a Guaranteed item from OC Depot, it should perform as described. In the rare situation that this is not the case, we will send a replacement upon safe return of the original item within 30 days of receiving the item. If a replacement is not available we will honor the terms of our Money-Back Guarantee.
ADDITIONAL INFORMATION:The following is the Console Log from this item:
U-Boot 1.1.3 (Mar 12 2015 - 11:19:59)
CPU: 8548, Version: 2.1, (0x80310021)
Core: E500, Version: 2.2, (0x80210022)
Clock Configuration:
CPU:1199 MHz, CCB: 399 MHz,
DDR: 199 MHz, LBC: 49 MHz
L1: D-cache 32 kB enabled
I-cache 32 kB enabled
Board: Zentron
CPU Board Revision 255.198 (0xffc6)
PCI2: disabled
I2C: ready
DRAM: initdram: Initializing DDRSDRAM
initdram: Normal boot in progress
dimm_spd_sdram 2001: memsize = 800
initdram: Call ddr_enable_ecc dram size -2147483648
DDR: 2048 MB
POST RAM test disabled.
Adjusted memory 0x7d000000 2097152000
Now running in RAM - U-Boot at: 74f7d000
trap_init : 0x0
system inventory subsystem initialized
FLASH: 4 MB
L2 cache 512KB: enabled
CPLD: Init complete
ATA interface setup upm 256: ffcff00, ffcfc04, ffffc00, fffffc01
PCI: gd->brcd_flags = 0, PCI init
Skip our host bridge
00 11 8086 b555 0680 1a
00 12 8086 b555 0680 1a
00 13 8086 b555 0680 1a
00 14 1033 0035 0c03 3b
00 14 1033 00e0 0c03 3b
CPLD rev: 0xd6
CPU0 CPLD version: 0xba
In: serial
Out: serial
Err: serial
Net:
ENET2: PHY is not applicable
ENET1: PHY is Broadcom BCM5461S 10/100/1000 BaseT PHY (2060c1)
ENET0: PHY is Broadcom BCM5461S 10/100/1000 BaseT PHY (2060c1)
ENET3: PHY is Broadcom BCM5461S 10/100/1000 BaseT PHY (2060c1)
board_init_r: Adjusted ram 2097152000 0x7d000000 2048000k
Checking system RAM - press any key to stop test
Checking memory address: 00100000
System RAM test using Default POST RAM Test succeeded.
set_bootstatus: BS_LOAD_OS, platform_idx = 2
Hit ESC to stop autoboot: 0
Map file at LBA sector 0x15a43f
do_bootm 171: load_addr 0x02000000 addr 0x00400000
do_bootm 174: ## Booting image at 00400000 load_addr 0x02000000 ...
Image Name: Linux-2.6.14.2
Image Type: PowerPC Linux Multi-File Image (gzip compressed)
Data Size: 2675395 Bytes = 2.6 MB
Load Address: 00000000
Entry Point: 00000000
Contents:
Image 0: 1596720 Bytes = 1.5 MB
Image 1: 1078663 Bytes = 1 MB
Uncompressing Multi-File Image ... do_bootm_linux 565: ## Current stack ends
at 0x74F5BB38 => set upper limit to 0x00800000
## initrd at 0x00585D7C ... 0x0068D302 (len=1078663=0x107587)
Loading Ramdisk to 1fef8000, end 1ffff587 ... OK
initrd_start = 1fef8000, initrd_end = 1ffff587
## Transferring control to Linux (at address 00000000) ...
tlbcam_index=11
mpc85xx_setup: Doing Pcie bridge setup
cpld_init: Map PCI RAS device
Installing Linux 2.6 Kernel
Attempting to find a root file system on hda1...
INIT: version 2.78 booting
Bypassing firmware validation.
INIT: Entering runlevel: 3
loading bonding module
Starting Fabric OS Services...
FIPS off, RRD...
sys_chip_init: class 0 max 24 Done
ethsw_ha_enabled = 1
main-cpu in Pluto...
HASM enable auto-reboot
Probe for PCI timeout detect
Detected 2 CPs in Chassis.
Fabric OS (sdc_dcx_B)
sdc_dcx_B console login: Proxy: ip2ipc started (run=1, rc=0), debug=0
Proxy: ipc2ip started (rc=0)
2021/10/26-11:52:41, [HAM-1004], 2534, SLOT 4 | CHASSIS, INFO, sdc_dcx_B, Proces
sor rebooted - Reboot.
Open heartbeat: 4d0005
Open heartbeat: 3f0104
Internet Systems Consortium DHCP Server 4.0.0
Copyright 2004-2007 Internet Systems Consortium.
All rights reserved.
For info, please visit https://www.isc.org/sw/dhcp/
Wrote 0 class decls to leases file.
Wrote 0 leases to leases file.
Listening on LPF/eth2/50:eb:1a:e9:cf:96/backplane
Sending on LPF/eth2/50:eb:1a:e9:cf:96/backplane
Sending on Socket/fallback/fallback-net
2021/10/26-11:52:53, [FV-1001], 2535, SLOT 4 | CHASSIS, INFO, sdc_dcx_B, Flow Vi
sion daemon initialized.
SNMP Research EMANATE/Lite Agent Version 16.2.0.9
Copyright 1989-2006 SNMP Research, Inc.
Fabric OS (sdc_dcx_B)
sdc_dcx_B login: admin
Password:
Warning: Default password not changed for 'root' and 'factory'. Please login as
'root' to change them.
Warning: Default password not changed for 'root' and 'factory'. Please login as
'root' to change them.
sdc_dcx_B:FID128:admin> POST1:Slot 6 Script PASSED with exit status of 0 Tue Oct
26 11:53:40 PDT 2021 took (0:0:21)
POST2:Slot 6 started running Tue Oct 26 11:53:41 PDT 2021
POST2:Slot 6 Test #1 - Running portloopbacktest -lb_mode 8
BLADE ID 99 in slot 6 reset, mode:5
BLADE ID 99 in slot 6 reset, mode:5
sdc_dcx_B:FID128:admin> licenseshow
Extended Fabric license
Fabric Watch license
Performance Monitor license
Trunking license
Adaptive Networking - obsolete license
Server Application Optimization - obsolete license
Fabric Vision license
sdc_dcx_B:FID128:admin>exit Please Click Here to Visit Our StoreSearchBy8 - 234737 | Loc: W51 | L: Jack |T: | PM: Nick | QTY: 0| Plan: L1- Q2 5 pounds or more |40.00"x40.00"x22.00"208.00lbs |Start: $0.00 | BIN: $899.99 | |10/27/2021 ||51268
