Power Over Ethernet Kit for 4xRaspberry Pi
(250M 4ports PoE Switch+ Micro USB PoE Splitter)
for Raspberry Pi B/B+/2/3
SupportEXTEND mode, max Network Cable length to250 meters
NOTE. WhenEXTEND mode enable, the Max bandwidth for thePower Link (PoE) port 1-4network port will bereduced to 10Mbps for each one.
(The up-link is not affected, it will always working at 100Mbps max speed)
PoESwitch Specification:
ALL Port:Standard 10/100Mbps Ethernet port. Support 10Mbps Ethernet and 100Mbps Fast Ethernet, can operate in full-duplex or half-duplex mode,must work with4 pairs UTP Cat5/5e/6 cable。Power LinkPort1-4:any supported unsolicited power on pairs 45-78 pins compliant Powered Devices (PDs)Power LEDLED ON: power on. LED OUT: power off GreenLight LINK/ACTLED ON Indicates the port is connected to a network device and has been startedLED OFF Indicates that this port is not connected to a network device or has not been started
Standard
IEEE 802.3 10BASE-T Ethernet
IEEE 802.3u 100BASE-TX Fast Ethernet
IEEE 802.3x Full-Duplex flow control
Protocol
CSMA/CD Ethernet
Data TransferRate
Ethernet: 10Mbps (Half Duplex)20Mbps (Full Duplex)
Fast Ethernet: 100Mbps (Half Duplex)200Mbps (Full Duplex)
IC Chips
IC Plus IP178G
Network Media(Cable)
10Base-T(EXTEND mode): UTP category 5e, 6 cable (maximum 250m) EIA/TIA-568 100Ω STP (maximum 250m)
100Base-TX:UTP category 5, 5e cable (maximum 100m) EIA/TIA-568 100Ω STP (maximum 100m)
PoE Power on RJ45
Power +: pin 4 & pin 5 ; Power -: pin 7 & pin 8
DC Output: 52V, Per port Max 1A or 50Watt, 4 POE ports Total Max. 75Watt
Number of Ports
5x 10/100Mbps Auto-Negotiation RJ45 ports with4 PoE enabled (port-1~ port-4)
Power Input
AC Input: 110V ~ 240VAC, 50Hz ~ 60Hz.
DC OutPut: 52V/1.85A
Power Consumption
3.2Watts (max. no PD connected)
According to the actual power consumption of equipment
Temperature
Operation Temperature:0 ~40℃(32 ~104℉)
Storage Temperature: -40 ~70℃(-40 ~158℉)
Humidity
Storage Humidity 5%~90% non-condensing, OperatingHumidity 10%~90% non-condensing
Product Dimensions
132mm W x 66mm D x 32mm H
RAM Register Capacity
64K bytes per device
MAC Address List
1K entries per device
Frame Forward Rate
10Mbps Ethernet: 14880pps/Port
100Mbps Ethernet: 14880pps/Port
PoE Splitter Specification:
Compliant with IEEE802.3af
Isolation: 2.5kV
Power Input: DC44~57V
Power Output: DC5V 2.4A
Data&Power INPUT Port: from RJ45 female (Compliant with IEEE802.3af/at PoE)
Data Output Port: RJ45 Male
Power Output Port:Micro USB Power Plug
Data Transfer Rate: 10/100Mbps
Devices will be detected before poe input
Power Pin:support both 1/2(+/-),3/6(-/+) or 4/5(+),7/8(-)
Body size: 80 x 27x 22 mm
DC cable length:165mm
RJ45 Modular Plug cable length:155mm
Weight : 55g
Item Included:
Output5V 2.4AActive PoE Splitter(Micro USB Power Plug) x4
75Watt 5pots 4PoEPassivePoE switch(DSLRKIT MID4P1U-E250)x1
AC power plug is AU or EU type,if you need other type (US or UK),Please leave a message.
![Buy Now Buy Now](buy.gif)