Specifications:The Wi-Fi Repeater is a Combined Wired/Wireless Network Connection DeviceLatest software wizard for easy setupAccess to Wireless standard 802.11n with Wireless Transmission Speeds of Up to 300MbpsEasy to Extends the Range of your WIFI Network, No Worry about Obstacles Weakening your WIFI SignalAlso Works Well with Other 11b/g and 11n Protocol Wireless ProductsImproves Wireless Coverage in all WLAN NetworksProvides up to 300Mbps Transmission RatesDownward complies with 802.11g (54Mbit/s) and 802.11b standard (11Mbit/s)Operating Temperature : 0ºC~40ºCStorage Temperature: 10~70ºCRelative Humidity (Operational) :10%~90% , noncondensingRelative Humidity (Storage) :10%~90% , noncondensingSupport 2.4 GHz WLAN networksSupport Wireless Repeater Mode and Standard AP ModWireless access point or network extender to bring WIFI to your home, study, or officeAntennas integratedMaximum WLAN security with WPA2, WPA, and WEP (128/64)Use it to Extend the Range of your WIFI Network Over a Wider Area or Eliminate dead-spots due to low signal powerNo Trailing Wires around the placeDistance: Outdoors 300m, Indoor 100m (According to the Actual Environment Change)Package Includes:1x Wireless WIFI Extender Repeater (US Plug)1x Installation Manualin case the quick installation guide wasn’t helpful, we can guide you through the installation process.1) Plug the Wi-Fi extender into the outlet closest to your router2) Using an ethernet cable, connect the extender to your router (not modem)3) Hold down the WPS button for about 5 seconds4) Go to the Wi-Fi / Network selection at the bottom-right of your screen5) Connect to the network that says “WiFi-Repeater”6) Enter a web browser, then copy and paste the following in the address barhttp://192.168.10.1/7) Type in “admin” in all lowercase letters for BOTH username and password8) This will bring you to a screen with colored boxes, click the box that says “Repeater Wizard”9) Select which Wi-Fi network you want to extend the range of, then type in your Wi-Fi password where it says “Key”-If you don’t know your password, that’s fine. Just make up a new one. Once you do it will be the password to your original network, as well as your extension.10) Click “Save” and then “Apply”. Just let the Repeater/Extender restart, and you are good to go!