HP Server PSU to ATX PSU Adapter | Low Profile & StandardYouTube and further details

• Details:This is a custom made for a HP server power supply mount that adapts to a full size ATX power supply mount. This is NOT a common product and you the consumer will have to check if this product will work for you. Printed in ASA filament and temperature resistant to 100C or 212F.

The Low Profile Mount is designed for open air frames such as the Veddha frame for crypto mining. The LP mount can be mounted if T-slot nuts using the mid screw holes (check photos) on either the LP or standard size mount. The other holes are for mounting to wood or metal.
The Standard Mount is designed for Enclosed Crypto Mining Cases or a Desktop Computer. The mount with HP server PSU and Breakout board (depending on your breakout board size) will measure 10.25in or 11.25in when inside a PC case.

• Setup:Both Adapters are the same when slotting the HP PSU in. Slide the PSU until it clicks into place. Then slot your breakout board on the PSU. The standard size mount should be mounted to the ATX PSU of your PC or case first and then mount the HP server PSU. Be sure to look closely at the photos or watch this YouTube If you have any questions be sure to ask.
  NO HP SERVER PSU INCLUDEDScrews ARE included (6/32 Hex Screw)
  Made By: 3D Print Master LLC